Glacier Fresh Replacement for LT700P, 46-9690 Refrigerator Water Filter, 3-Pack

Yes — they are exactly the same filter. 9690 and 46-9690 are simply two different ways Kenmore catalogs the same part number (the "46-" prefix is Kenmore's standard catalog designation). Both refer to the same filter cartridge, which is itself the Kenmore-branded equivalent of the LG LT700P (ADQ36006101). The GlacierFresh GF-700P replaces all of them interchangeably.

The fastest way is to check the label on your currently installed filter — it will show the part number (9690, 46-9690, LT700P, or ADQ36006101) directly on the cartridge. You can also check inside the filter housing for a sticker, or look up your Kenmore fridge model number against our compatibility list. If your model is among the LFX, LFD, LMX, or LFXS series listed in our compatibility guide, the GF-700P is almost certainly your filter.

A 3-pack is excellent value and the extras won't go to waste. Unopened filters have a shelf life of 2–3 years when stored in a cool, dry place away from direct sunlight and strong odors. Since each filter lasts 6 months, a 3-pack covers 18 months of filtration — well within the shelf life. You'll save money per filter, reduce reorder frequency, and always have a replacement ready when the indicator light turns red.

Not defective — just not flushed yet. A musty or earthy taste in the first few cups after installation is caused by carbon fines released from the new filter media during initial use. This is completely normal for any carbon block filter. Run and discard at least 2 gallons (8–10 dispenser cups) before drinking. The taste should clear up completely after flushing. If it persists beyond 3 gallons, ensure the filter is fully locked in place — a loose filter can allow unfiltered water to bypass the carbon block.

Leaking from third-party filters is almost always a fit tolerance issue — the filter housing dimensions don't match the OEM spec precisely enough to create a watertight O-ring seal. The GlacierFresh GF-700P is precision-engineered to match OEM dimensions exactly, including the O-ring groove geometry. To ensure a leak-free install: insert the filter and twist clockwise until you feel and hear a firm click — don't stop at the first resistance. A fully locked filter should have zero dripping. If you experience leaking after a proper install, contact us and we'll replace it immediately.

Both. The GF-700P filters all water flowing through your refrigerator's internal water system — the door dispenser and the ice maker draw from the same filtered water line. Replacing this filter improves both your drinking water and your ice quality simultaneously. After installing a new filter, discard the first 1–2 ice batches as they may contain residual carbon fines from the new filter.

After installing the new filter, press and hold the "Filter Reset" or "Water Filter" button on your Kenmore's control panel for 3–5 seconds until the indicator light resets from red to green or turns off. On some models, the reset button is located inside the fridge near the filter housing rather than on the door panel. Your Kenmore fridge does not auto-detect a new filter — you must manually reset the indicator every time you replace it, or the light will stay red indefinitely.

Yes. Under the Magnuson-Moss Warranty Act, appliance manufacturers — including Kenmore/Sears — cannot void your warranty simply because you used a compatible third-party replacement filter. They would need to prove the third-party filter specifically caused a malfunction to deny a warranty claim. The GlacierFresh GF-700P is precision-engineered to OEM specifications and certified by NSF/ANSI and IAPMO, making it a safe and legally protected choice for warranty-covered refrigerators.